System-sensor FAAST Networking Bedienungsanleitung PDF herunterladen (Seite 32)

User Guide: FAAST Fire Alarm Aspiration Sensing Technology® Networking

Server Requirements

The mail server will accept messages from the FAAST detector and attempt to relay them to the speciﬁed recipients. This server must

meet the following requirements:

• Accept and deliver messages from the e-mail address speciﬁed in the Sender Account ﬁeld.

• Accept and relay SMTP messages from port 25 without requiring authentication.

• Have connectivity and DNS service to networks (such as the Internet) where recipient mail servers reside.

E-mail Client Requirements

Once connectivity to the mail server is established, the integrated SMTP client will communicate with the server to deliver alarm and

fault e-mail notiﬁcations. For the client to work properly, the following are required:

• The Sender Account ﬁeld is used to populate the SMTP “From” ﬁeld and speciﬁes where an e-mail message originates. This

ﬁeld should be populated with an e-mail address speciﬁcally reserved for the detector. An e-mail account may need to be cre-

ated and added to the mail server by the server administrator.

• Up to 6 recipient e-mail addresses and desired notiﬁcations must be conﬁgured.

E-mail Client Conguration

The integral SMTP client is conﬁgured using the PipeIQ software. Before attempting to conﬁgure the e-mail client, the IP conﬁguration

of the detector should be completed and network connectivity veriﬁed. For instructions, see the TCP/IP Connectivity section earlier

in this guide.

1. Start the PipeIQ software application.

2. Open the project for it using File -> Open.

3. Double-click the desired device to open the Conﬁguration window.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Keine Kommentare

System-sensor FAAST Networking Bedienungsanleitung Seite 32